Filter
Top Products
Problem solving guide
48
Other problems
Problem Cause and remedy
The drying process
goes on
too long or
even switches off *
The room in which the dryer is located is too warm.
V
entilate the room thoroughly.
Detergent residues, hair and fine fluff can clog the
filt
ers.
Clean
the fluff filters and the plinth filter.
Remove any visible fluff:
. .
. bottom left, from behind the panel in the heat
exchanger cavity (see "Cleaning and care");
. . . from the cooling fins behind the grille bottom
right (see the end of this section).
The cool air intake (bottom right grille) is blocked.
Move any objec
ts, such as a laundry basket, away
from the dryer.
The fluff filters and the plinth filter were wet when
r
eplaced.
The fluff filt
ers and the plinth filter must be dry.
The laundry is too damp.
Spin using a higher spin speed in the washing
machine.
The tumble dryer has been overloaded
Do not e
xceed the maximum load for the
programme selected.
Metal zips have prevented the dryer from registering
the corr
ect moisture level.
Op
en the zips next time.
If
the problem recurs, dry these items using the
Warm air timed drying programme.
* Before starting another programme:
Switch the dr
yer off and then on again.
There are humming
noises
The compressor is operating.
T
hese noises are quite normal and do not indicate a
fault.