Filter
Top Products
Adjusting the adapter strips to
the height of adjacent drawers
The height of the adapter can be ad-
justed in one of two ways:
– by altering the position of the nuts or
– by removing strips.
Adjustment range for the adapter
strips: max. 10 mm upwards (see ar-
rows in the illustration).
For adjustment downwards to max.
25mm additional adapter strips
together with longer screws are avail-
able from Miele dealers or the Miele
Spare Parts Department.
After adjustment has been made,
cut or pinch off any excess length
of the plastic screw.
Fitting the front panel
The front of this appliance can be fitted
with a furniture panel to match sur-
rounding units.
If the unit is fitted in a Miele kitchen, a
front panel with the appropriate dimen-
sions and the necessary holes pre-
drilled can be provided.
If the kitchen is from a manufacturer
other than Miele, it is recommended
that the panel be cut to size and
drilled by a specialist according to
Miele specifications.
Front panel dimensions:
Height: 570 mm (+10/-25 mm)
Width: 588-596 mm
Thickness: up to 19 mm (at the edges)
The template provided serves to locate
and drill the fixing holes for non-Miele
front panels.
Place the template along the lower
edge of the rear of the front panel.
There are four short parallel markings
at each corner of the template.
Use these markings to centre the
template.
Example:
With a front panel width of 594 mm
each second marking from inside must
line up with the left and right hand out-
side edges of the panel.
Installation
36