Filter
Top Products
Check and indicator lights:
What to do if . . . Cause . . . Remedy . . .
. . . the “Locked” indicator
light flashes when the ma-
chine is switched on.
The system lock is activated.
The programme cannot be
started.
See section “Electronic system
lock”.
. . . the “Locked” indicator
light comes on during drying.
That is not a fault. The light will go out at the end of
the programme.
. . . the “Drying” indicator
light flashes.
The programme selector was
moved after the beginning of
the programme. The
programme continues to run
normally.
Turn the selector back to its
original position and the light
will go out.
. . . the “Anti-crease/Finish”
light flashes.
There could be a fault.
– Switch the machine off and
on again.
– Select the programme and
press “START”.
Cold surrounding temperatures
below freezing are affecting the
machine (frozen condensed
water).
– Install the appliance in a
warmer room.
If the light continues to flash there
is a problem. Contact Miele
Service Department.
. . . the “Empty out container”
light comes on.
The condensed water container
is full.
Empty the container.
Check that the condensed
water container is correctly
positioned.
. . . the “Clean out airways”
light comes on.
The fluff filters or the condenser
unit are blocked.
– When the programme has
ended, clean the filters (see
section “Cleaning and care”).
– Clean the condenser unit
and check that it is correctly
positioned.
The electronics are registering
that the machine is
underloaded.
Always load the machine to full
capacity for economical drying.
Problem solving guide
30