Filter
Top Products
25
Cycle time too short
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
■ Is the automatic cycle ending early?
The load may not be contacting the sensor strips. Level the dryer.
Change the dryness level setting on Sensor Cycles. Increasing or decreasing the dryness
level will change the amount of drying time in a cycle.
Lint on load
■ Is the lint screen clogged?
Clean lint screen. Che
ck for air movement.
Stains on load or drum
■ Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of
the cycle. Fabric softener sheets added
to a partially dried load can stain your garments.
Drum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to
other clothing.
Loads are wrinkled
■ Was the load removed from dryer at the end of the cycle?
Select Custom Refresh cycle to tumble the load
with water and heat to help smooth out
wrinkles from a load left in the dryer.
■ Was the dryer overloaded?
Dry smaller loads that can tumble freely
. Smaller loads yield best results with the Rapid
Refresh Small Load cycle. Results may also vary depending on fabric type. This cycle is
best for reducing wrinkles and odors from loads consisting of wrinkle-free cotton, cotton
polyester blends, common knits, and synthetics.
Odors
■ Have you recently been painting, staining, or varnishing in the area where your dryer is
located?
If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry
the clothing.
■ To remove odors left in garments after wearing, select the Rapid Refresh Small Load cycle
for small loads of two to four garments. This cycle is best for reducing wrinkles and odors
from loads consisting of wrinkle-free cotton, cotton polyester blends, common knits, and
synthetics.