Filter
Top Products
Page 5
ADDITIONAL GROUNDING CONNECTIONS
A grounding kit (Part No. 12001875) is available. It contains the ground wire,
clamp, ground screw and washer. Connect the ground wire to back of unit with
the cabinet ground screw and washer. Secure the other end of ground wire to a
grounded COLD metal water pipe.
NEVER CONNECT GROUND WIRE TO PLASTIC PLUMBING LINES, GAS LINES OR HOT WATER PIPES.
WATER
Water pressure of 20 to 120 p.s.i. is required to correctly fill the washer in the proper time. Pressures of less
than 20 p.s.i. may cause a failure in the water valve, detergent dispenser, fabric softener dispenser or bleach
dispenser. Low pressure may also cause the fill times to be extended past the time the washer is allowed to
fill. The water valve may not shut off completely when the pressure is insufficient.
Hot and Cold water faucet’s must be within 4 feet of the back of the washer for inlet hoses provided with the
washer. NOTE: Accessory inlet hoses are available in various lengths up to 10 feet for faucet’s more than 4
feet from the back of the washer. See accessory parts section.
TO AVOID THE POSSIBILITY OF WATER DAMAGE, SHOULD A HOSE LEAK, ALWAYS HAVE FAUCET’S
ACCESSIBLE AND TURN OFF FAUCET’S WHEN WASHER IS NOT IN USE.
Water heater should be set to deliver a minimum of 120° – 140° F (49° – 60° C) water to the washer.
REQUIREMENTS
ELECTRICAL
120 Volt 60 Hz 15 AMP Fuse or Circuit Breaker
Individual branch circuit serving only the washer is recommended.
NEVER USE AN EXTENSION CORD.
GROUNDING
ELECTRICAL GROUND IS REQUIRED ON THIS APPLIANCE.
Appliance is equipped with a power cord having a 3-prong grounding plug for use in a properly installed and
grounded outlet.
•
Improper connection of the equipment-grounding conductor can result in a risk of electrical
shock. Check with a qualified electrician or serviceman if you are in doubt as to whether
the appliance is properly grounded. Do not modify the plug provided with the appliance – if
it will not fit the outlet, have a proper outlet installed by a qualified electrician.
IMPORTANT SAFETY PRECAUTIONS
• To prevent unnecessary risk of fire, electrical shock or personal injury, all wiring and
grounding must be done in accordance with the National Electrical Code ANSI/FNPA, No.
70-Latest Revision and local codes and ordinances. It is the personal responsibility and obli-
gation of the appliance owner to provide adequate electrical service for this appliance.
WARNING
!
ACCESSORY PARTS:
Description Part Number
4 Ft. Fill Hose 33-7891
5 Ft. Fill Hose 33-7046
5 Ft. Fill Hose with 90 degree Elbow 200672
6 Ft. Fill Hose 21001466
6 Ft. Fill Hose with 90 degree Elbow 200688
10 Ft. Fill Hose 21001467
Descr
iption Part Number
4 Ft. Stainless Steel Braided Hose 22002733
5 Ft. Stainless Steel Braided Hose 22002734
Hose Washer Kit 12001413
Drain Hose Extension Kit 12001660
Pump Accessory Kit 12001674
Grounding Kit 12001875