Filter
Top Products
20
7-4. ERROR DISPLAY
If you press the [Start/Pause] button when an error in displayed, any error except software ERROR will
disappear and the machine will change into pause status.
In case of , , , if the error is not resolved within 15 sec. In case of other errors, if the
error is not resolved within 4 min. Power will be turned off automatically and the error only will be
blinked. But in the case of , power will not be turned off.
ERROR SYMPTOM CAUSE
WATER INLET
ERROR
Water has not reached to the pre-set level within 4 min.
since inlet valve operated, or water has not reached to
the normal level within 25 min. Page 21
1
UNBALANCED
ERROR
2
WATER OUTLET
ERROR
3
OVERFLOW
ERROR
4
The appliance is tilted.
Laundry is gathered to one side.
Non distributable things are put into the drum.
Page 22
Water has not drained enough within 8 min. Page 23
Water is automatically being pumped out because too
amuch water is in the tub. Page 25
PRESSURE SENSOR
S/W ERROR
5
The sensor pressure switch is out of order. Page 26
DOOR OPEN
ERROR
6
The [Start/Pause] button is pressed with the door open.
The door switch is out of order. Page 27
THERMISTOR(HEATING)
ERROR
7
The thermistor is out of order. Page 28
POWER
FAILURE
10
The washer experienced a power failure.
CURRENT
ERROR
8
PWB ASSEMBLY (Main) is out of order
Replace the PWB assembly (Main)
Winding in the MOTOR is short-circuited.
Replace the MOTOR
MOTOR
LOCKED
ERROR
9
The Connector (3-pin, male, white) in the wire harness
is not connected to the Connector (3-pin, female, white)
of MOTOR.
Reconnect or repair the connector
The electric contact between the connectors [3-pin,
male, white in the wire harness and 6-pin, female, white
in the PWB ASSEMBLY (Main]) is bad or unstable.
Reconnect or repair the contact in the connector
The wire harness between the MOTOR and PWB
ASSEMBLY (Main) is cut (open circuited).
The hall sensor is out of order/defective. Page 29