Filter
Top Products
• If you are not using your machine for a long time, unplug from the
mains supply, close the water supply and leave the door open in
order to keep the inside of the machine dry and prevent unpleasant
odours.
• As a result of the quality control procedures, a certain amount of
water may remain in your machine. This is not harmful for your
machine.
SECTION 2: INSTALLATION
You must pay attention to the following issues before using your washing
machine.
REMOVAL OF TRANSPORTATION SCREWS
• Transportation screws, which are located at the back of the machine,
must be removed before running the machine.
• Loosen the screws by rotating counterclockwise by a suitable wrench.
(DIAGRAM-1)
• Remove the screws by pulling them.(DIAGRAM-2)
• The plastic parts located in the interior part of your machine will fall
down under the device.
• Lift your machine up slightly, pick up the plastic parts(2 persons
recommended).
• If all of the plastic parts of screw groups have not fallen down; open
the door of your machine,move the drum until all plastic parts fall
down. Collect the parts that have fallen to the floor. There are two
plastic parts per screw.
• To the holes where the transport screws have been removed, insert
the plastic transport screw caps found in the accessories bag.
(DIAGRAM-3)
• The transportation screws, that have been removed from the machine
should be kept for any other transportation necessities.
DIAGRAM-2
DIAGRAM-1 DIAGRAM-3
ADJUSTMENT OF FEET
• Do not install your machine on rugs or similar surfaces.
• For your machine to work silently and without any vibration, it should
be installed on a flat, non-slippery and tough ground.
3