Filter
Top Products
SIPHON PLUG
Pull out the detergent drawer. Remove the siphon plug and clean the
residues of the softener thoroughly.Replace the plug.
THE CABINET
NOTE:Disconnect from the mains supply before cleaning.
Clean the exterior surface of the cabinet of your machine with lukewarm water
and a cleaning substance that will not irritate the cabinet. After rinsing with
clean water, wipe it with a soft and dry cloth.
WARNING!
If the machine is installed in a location where the temperature can fall below
0 ˚C, do the following when it will not be in use:
• Plug in the machine.
• Close the water tap and pull out the water inlet hose or hoses from
the tap.
• Place the ends of the water drain and water inlet hoses in a cup on
the ground.
• Adjust the program knob to “Draining” program.
• The program ready light will be on.
• Run the program by pressing the start/pause button.
• Unplug your machine when the program is over (program end light is
on).
When you complete this proces, the remaining water inside the machine will
be drained and thus formation of ice in the machine will be prevented. When
you operate your machine again, be sure that the temperature is above 0 ˚C.
THE DRUM
Do not leave metal parts like needles, staples or coins inside your machine.
These pieces cause formation of rust stains in the drum. To eliminate these
stains of rust, use a cleaning substance without chlorium and follow the
warnings of the cleaning substance producer. For cleaning rust stains, never
use dish-washing wires or similar rough objects.
REMOVAL OF LIMESCALE FROM YOUR MACHINE
If you arrange the amount of the detergent you use in your machine properly,
there will be no need for limescale removal. However, if you desire to apply
the removal procedure, use the limescale protectors in the market and pay
attention to their warnings.
WARNING!
The lime eliminating substances contain acids and this may cause colour
modifications in your clothes along with an adverse effect on your machine.
23