Filter
Top Products
Filling detergent in the machine
The quantity of the detergent that you will fill in your machine depends on the
following criteria:
• Your detergent consumption will change according to the soil level
of your clothes. For your slightly dirty clothes, do not pre-wash and
put a small amount of detergent in the compartment no.2 of the
detergent drawer.
• For your excessively dirty clothes, select a program with pre-
washing, fill ¼ portion of the detergent you will put in compartment
1 in the detergent drawer and the remaining portion in compartment
2.
• In your machine,use the detergents developed especially for
automatic washing machines. The quantities that will be used for
your clothes are written on the packing of the detergents.
• As the hardness of your water increases, the amount of the
detergent to be consumed will also increase.
• As the amount of your clothes increases, the amount of the
detergent to be consumed will also increase.
• Fill your softener in the softener compartment in your detergent
drawer. Do not exceed the MAX level. Otherwise, the softener will
diffuse in the washing water via the siphon.
• The softeners with high density should be diluted with some water
before filling in the drawer. That is because the softener with high
density obstructs the siphon and prevents the flow of the softener.
• You can use fluid detergents in all programs without pre-washing.
For this, mount the fluid detergent level plate in the second
compartment of the detergent drawer and arrange the amount of
fluid detergent according to the levels on this plate.
OPERATING THE THE WASHING MACHINE
Selection of the programme
• Select the programme suitable for your clothes from Table-1(Page 17).
• Adjust the programme that you have selected by using programme knob.
• The cycle time will be displayed.
NOTE: If you are trying to spin a small load the appliance may take some
time to balance the load before spinning commences. You may need to
increase the load to successfully complete the spinning cycle. To conserve
energy we recommend spinning full loads.
12