Filter
Top Products
I I
BEFORE CALLING FOR SERVICE (cont.)
Water in the washer drains
slowly or not at all, or the
display shows:
Washer fills with water
slowly or not at all, or the
display shows:
II ;Ell
Washer will not turn on
The display shows:
The display shows:
| ",-i,_|
Wash cycle time is longer
than usual
• Drain pump filter clogged.
• Drain hose is bent, pinched, or
clogged.
• Drain pump failed.
• Water supply taps are not open fully.
• Water line hoses are kinked,
pinched, or bent.
• Water inlet filters are clogged.
• Water pressure to tap or house is
too low.
• Power cord is not properly plugged in.
• House fuse is blown, circuit breaker
has tripped, or power outage has
occurred.
• The lid is not closed properly.
• Lid lock switch error
• The washer automatically adjusts
the wash time for the amount of
laundry, water pressure, water
temperature, and other operating
conditions.
• Water level is too high due to a
faulty water valve.
• Clutch error
• Check and clean drain pump filter.
• Make sure the drain hose is free of clogs, kinks, etc., and is
not pinched behind or under the washer.
• Call for service.
• Make sure that the water taps are open fully.
• Make sure the hoses are not kinked or pinched. Be careful
when moving the washer.
• Clean the inlet filters. See the Care and Cleaning section.
• Check another faucet in the house to make sure that
household water pressure is adequate
• Make sure that the plug is plugged securely into a grounded,
3-prong, 120-VAC, 60-Hz. outlet.
• Reset circuit breaker or replace fuse. Do not increase fuse
capacity. If the problem is a circuit overload, have it correct-
ed by a qualified electrician.
• Make sure that the lid is closed properly and press the
START/PAUSE button. After starting a cycle, it may take a
few moments before the tub begins to turn or spin. The
washer will not spin unless the lid is locked.
• If the lid is closed and locked and the open lid error mes-
sage is displayed, call for service.
• If you press the START button while the lid is open, dE error
message will be displayed.
• Make sure that the lid is closed properly and press the
START/PAUSE button. The washer will not spin unless the
lid is locked.
• If the lid is closed and the lid lock error message is
displayed, call for service.
• This is normal. The washer adjusts cycle time automatically
to provide optimal results for the selected cycle.
• Close the water taps, unplug the washer, and call for
service.
• Mechanical failure.
• Unplug the washer, and call for service.
27
I I