Filter
Top Products
8
Door reversal
1 Warning! The door may only be reversed by a
specialist.
Instructions for qualified personnel/specialist
Warning! Before reversing the door, disconnect the mains
plug; with a permanent connection: remove the fuse.
1.Open door.
2.Unscrew hinge A from the front of the machine and take
off the door.
3.Carefully pry off cover plates B and C. To do this, insert a
thin screwdriver into the slots as shown in the illustra-
tion, press downwards slightly and pry out the cover
plates.
4.Unfasten locking block D from the snap-on fixture, take
out and reinsert on the other side, having rotated the
block through 180°.
5.Unscrew hinge A from the door, rotate through 180°, re-
insert on the opposite side and screw down.
6.Reinsert cover plates B and C on the opposite site having
first rotated them through 180°.
7.Unscrew cover plates E from the front of the machine,
rotate through 180, screw on the opposite side.
8.Unscrew door lock F, push down slightly and remove
from the front of the machine.
9.Press snap-in button G in and down, press cover down
slightly and remove from front of the machine.
10.Transfer door lock F to the oppositeside and screw
down.
11.Fix cover G on to the other side and allow the snap-in
button to lock in place.
12.Insert door and hinges into recesses on the front of the
machine and screw down.
Note regarding contact protection: The machine is
only secure for operations again once all plastic parts have
been inserted.