John Lewis JLTDC01 Clothes Dryer User Manual


 
18
Emptying the water reservoir
Empty water reservoir after every drying cycle.
If the water reservoir is full, an active programme will be in-
terrupted automatically and the FULL TANK display will
light up. In order to continue the programme, the water
reservoir must be emptied.
1 Warning! The condensed water is not suitable for
drinking or for preparing foodstuffs.
1.Take out drawer containing water reservoir completely
(1) and pull up the water reservoir’s drainage pipe as far
as it will go (2).
2.Pour condensed water out into a sink or other suitable
container.
3.Slide outlet connections in and refit water reservoir.
If the programme has been interrupted as a result of the
water reservoir being full:
Press the START/PAUSE button to continue the drying cy-
cle.
3 The water reservoir has a volume of approx. 4 litres.
This is sufficient for around 6kg of laundry which has
previously been spun at 800 revolutions/minute.
3 The condensed water can be used as distilled water,
e.g. for steam ironing. However first filter it (e.g.
with a coffee filter) to remove any residue and small
pieces of fluff.
3 If there is suitable plumbing located nearby, then the
drain kit could be fitted. Please refer to page 23.
Cleaning the drum
1 Warning! Do not use abrasives or steel wool to
clean the drum.
3 Lime in the water or cleaning agents may form a
barely visible lining on the inside of the drum. The
degree to which the laundry has been dried is then
no longer detected reliably. The laundry is damper
than expected when removed from the dryer.
Use a damp cloth, which has been soaked in water and a lit-
tle vinegar, to wipe the inside of the drum and drum ribs.
Clean operating screen and
housing
1 Warning! Do not use furniture cleaners or aggres-
sive cleaning agents to clean the machine.
Use a damp cloth to wipe down the operating screen and
housing.
Changing the bulb for interior
lighting
Only use a special bulb which is designed specially for dry-
ers. The special bulb can be obtained from the Customer
Care Department, ET no. 112 552 000-5.
3 Important: When the appliance is switched on, the
interior lighting switches itself off after 5 minutes
when the door is open.
1 Warning: Do not use standard bulbs! These devel-
op too much heat and may damage the appliance.
1 Warning: Before replacing the bulb, disconnect the
mains plug; with a permanent connection: fully un-
screw or deactivate the fuse.
1.Unscrew cover above the bulb (this can be found directly
behind the loading aperture, at the top; refer to “Descrip-
tion of machine” section.)
2.Replace defective bulb.
3.Screw cover back down.
1 Warning: For safety reasons, the cover must be
screwed down tightly. If this is not done, the dryer
must not be operated.