Filter
Top Products
7
Unpacking
Warning!
1 Slide out the polystyrene bag containing the polysty-
rene block before using the appliance. Pull off adhe-
sive strips from inside machine on top of drum.
Keep all packaging away from children.
Transporting the appliance
1 Warning: Only tip the appliance on its left side to
transport (see illustration), if it cannot be transport-
ed in an upright position.
Positioning
It is recommended that, for your convenience, the machine
is positioned close to your washing machine.
The tumble dryer must be installed in a clean place, where
dirt does not build up.
To keep vibration and noise to a minimum when the dryer is
in use, it should be placed on a firm, level surface.
Once in its permanent operating position, check that the
dryer is absolutely level with the aid of a spirit level. If it is
not, raise or lower the feet until it is.
The feet must never be removed.
Specialist accessories
The following special accessories are available from your
Service Force Centre.
Stacking kit (optional accessory):
It should be possible to stack your new dryer on top of a
front loading washing machine with a covers depth of 60 cm
and width of 60cm.
Read carefully the instructions supplied with the stacking
kit.
Please contact your local John Lewis branch for further ad-
vice.
Version to be supplied:
Installation kit for external condensate
drain
Installation kit (125 122 510) for direct draining of conden-
sate into a basin, siphon, gully, etc. The condensate tank
then no longer has to be drained, it must however remain in
its intended position in the machine. Refer to the “Pro-
gramme options” section for how to deactivate the FULL
TANK display.
Max. displacement height: 1m from the base of the dryer;
max. displacement length: 3m
– with extractable stacker plate 916 019 103