Filter
Top Products
21
6. Select the spin speed or the
“Rinse hold” option
Press the “Spin” button repeatedly in order to select
the desired spin speed or the “Rinse hold” option. If
you select the “Rinse hold” option, the machine will
stop at the end of the programme with the water still
in the tub. The relevant light will light up.
7. Select the desired options
If your laundry is very dirty, it may be advisable to
select the “Prewash” option.
If your laundry is only slightly soiled, select the
“Quick” option.
If you wish the laundry to undergo an extra rinse,
select the “Extra Rinse” option.
If your laundry has heavy stains and it is necessary to
prolong the washing time, select the “Stain” option.
The special detergent for stains (Stain remover) is
loaded from the compartment marked (Prewash)
.
If your laundry should not be creased, select the
“Quiet” option to leave the fabrics in the water of the
last rinse.
The relevant light illuminates.
Stain
Prewash QuietQuick
Extra
rinse
Rinse hold
Spin
900
700
500
1400
8. Select the “Delay start”
Before you start the programme, if you wish the
start to be delayed, press the “Delay start” button
repeatedly, or keep it pressed, to select the desired
delay.
The selected delay time value (up to 23 hours) will
appear on the display for 3 seconds, then the duration
of the programme will appear again.
During this period it is possible to load other laundry:
press the “Start/Pause” button. Open the door. Load
the laundry. Close the door and press the
“Start/Pause” button again.
9. Start the programme
Press the “Start/Pause” button. The relevant light will
stop flashing, and only the light relevant to the phase
that is in progress will remain lit. The machine starts
operating.
If you have chosen a delayed start, the washer dryer
will begin the countdown.
The display will show the duration of the programme
or the selected delay.
10. How to change an option
or a programme during its
cycle
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
machine by pressing the “Start/Pause” button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to “Off” and then
to the new programme position.
Start the new programme by depressing the
“Start/Pause” button. The washing water in the tub
will not emptied out.
Delay
start