Filter
Top Products
16
• “Quick”: select this option for laundry that is only
slightly soiled in order to obtain a good wash result in
a short time.
This option is not available with the Wool
programmes, the Energy saving programmes
“Economy” and “30 Minute wash”.
The washing time will be reduced according to the
type of fabric and the selected temperature.
• “Extra rinse”: this option can be selected with all
programmes, except the Wool programmes and “30
Minute wash”. The machine add 2 rinses for cotton
and 1 rinse for synthetics and delicates.
This option is recommended for people who are
allergic to detergents, and areas where the water is
very soft.
6 “Stain” button
Select this button if you wish to add to the washing of
heavy soiled laundry a stain phase: at the temperature
of 40°C pour a stain removing detergent into the
compartment marked (Prewash).
This function is available in cotton, synthetic and
delicates programmes with a temperature of
40° or higher.
The washing time will be prolonged by few minutes.
The “Prewash” and the “Stain” options cannot be
selected together.
7 “ Quiet” button
When you choose this option, the machine will not
drain the water of the last rinse, this will ensure the
minimum of creasing to laundry.
As all spinning phases are cancelled, this washing cycle
is very quiet and it can be useful at night or in hours
with more economical power rate.
The machine will perform 3 additional rinses on
cottons and 1 additional rinse on synthetics
programmes.
At the end of the cycle, the light corresponding to the
option “Quiet” and the “Rinse hold” pilot phase light
are on, the “Start/Pause” button light goes out and
the door cannot be opened to indicate that the water
must be drained.
A blinking zero will appear on the display.
To empty out water there are 2 possibilities:
- Select
“
Drain” programme and then depress the
“Start/Pause” button:
the water is emptied out without spinning.
- Select the “Spin” programme. Select the spin speed
by means of the relevant button and then depress the
“Start/Pause” button. The water is emptied out and
the laundry is spun at the selected spin speed.
Attention!
Before selecting
“
Drain” programme or “Spin”
programme the selector dial must to be positioned on
“Off”.
8 “Delay start” button
This button makes it possible to delay the starting of
the programme 30 min - 60 min - 90 min, 2 hours and
then by 1 hour up to a maximum of 23 hours.
The delay you have selected is shown on the display for
about 3 seconds; afterwards, the duration of the
programme reappears.
You must select this option after you have set the
programme and before you press the “Start/Pause”
button.
The time value shown on the display will decrease by
one unit every hour.
You can change the delay time at any moment,
before you press the “Start/Pause” button.
If you have already pressed the “Start/Pause” button,
and you wish to cancel the delay time, proceed as
follows:
• set the machine to PAUSE by pressing the
“Start/Pause” button;
• press the “Delay start” button until the symbol “
00’’
”
is displayed.
• press the “Start/Pause” button again.
Important!
• The “Delay start” cannot be used with “Drain”
or “Spin” programmes.
Note!
• With programme “Soak 30°” the selected delay (up
to a maximum of 10 hours) corresponds to the
soak time of the laundry in the drum.
• The door will be locked throughout the delay time.
If you need to open the door, you must first set the
washing machine to Pause by pressing the
“Start/Pause” button. After you have closed the door,
press the “Start/Pause” button again.