Filter
Top Products
17
9 “Start/Pause” button
This button has two functions:
• Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light above the button will stop flashing
and remain lit.
If you have selected a delay time, the countdown will
begin and will be shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme from the point at which it was
interrupted, press the button again.
Important!
You must set the washing machine to Pause before you
make any change in the programme in progress.
10 Display (Programme time)
The following pieces of information are shown on the
display:
• Reset/cancellation of the programme
If the programme selector dial is turned to “Off”
position, three blinking dashes are displayed.
Now you can select a new programme.
(If, at the end of a washing cycle, the programme
selector dial has not been turned to “Off” position ,
when you press the “On/Off” button to switch the
machine on for the next washing, the display will show
a blinking zero.)
• Duration of washing programme in hours and
minutes, after you have selected a programme (for
example 2.05).
The duration is calculated automatically on the basis
of the maximum recommended load for each type of
fabric.
---
While the programme is running (after you have
pressed the Start/Pause button), the displayed time
value decreases by one unit every minute.
• The washing machine has stopped with water
in the tub, when the “Rinse hold” or “Quiet”
option has been selected or at the end of the “Soak
30°”: this is indicated by a flashing zero.
• The washing machine has completed the
programme: this is indicated by a flashing zero.
• Delay start, a time value indicated in hours (23
hours max) and selected by means of the relevant
button.
Delay
start
0
1.25
2.05