Filter
Top Products
13
Recommendations regarding
the construction and fitting of
a base when the installation
requires an integrated
appliance to be raised
Where the appliance has been raised by mounting onto
a wooden base provided by the installer. The material
used to construct the base should have a non slip
surface, be water repellent and if possible be one solid
piece.
If it is not possible to use one solid piece, due to the
additional height required, ensure that any additional
strips of timber are glued and screwed to the underside
of the base (see Fig. F).
Drill four fixing holes see Fig. G
600-605 mm
50 mm
Front edge
Top view
95 mm
490 mm
G
600-605 mm
Front view
5 mm Hardwood strip
Additional pieces of
timber should run
from front to back
100 mm
40 mm
F
c) Mounting the door
Fix the hinges (1) to the machine by means of the
M5x15 screws (3-Fig. B). The hinges can be adjusted to
compensate for possible uneven thickness of the door.
To align the door perfectly it is necessary to loosen the
screw (3-Fig. B), adjust the door and tighten the screw
again.
d) Counter-magnet (6)
The appliance is pre-arranged for a magnetic closure of
the door. To enable a correct operation of this device,
it is necessary to screw the counter-magnet (6) (steel
disk + rubber ring) into the inner side of the door.
Its position must correspond to the magnet (4) on the
appliance (See fig. D).
If the door has to be opened from left to right, invert
the position of the plates (7), the magnet (4) and the
plate (5) (Fig. B and E). Mount the countermagnet (6)
and the hinges (1) as previously described.
4
6
5
1
2
3
7
E
P0983
P098
4
6
4
D