Filter
Top Products
9
How to Change the Water Drainage Hose
When fitting the water drainage hose to the
water drainage outlet
If the water drainage outlet is too shallow
or the end of the water drainage hose
touches the grounds, cut the end of the
water drainage hose in an oblique angle.
Water drainage hose which inserts into the unit, can 't
touch other parts, to prevent the damage caused by
water leakage.
The black or purple mark of the water
drainage hose should be inserted into the
corresponding groove of the unit.
Water drainage hose retainer must be tightened.
The inner section of the water drainage hose must be
secured by the retainer before fetched out.
Failure to do so may cause
insufficient rinsing or unit
malfunction due to poor drainage
or too much subbles during rinsing
and spinning.
Attention
Attention
Water
drainage hose
Water
drainage outlet
Water drainage hose is attached on the left side of unit at shipment, nonetheless, it can be
reattached on the right side to suit drainage needs.
2Purple mark
Water drainage hose outlet
3Hose retainer
1Drainage hose cover
Back
Black mark
Front
The water drain-
age hose pulled
out (right)
The water drain-
age hose pulled
out (left)
The water
drainage hose
Corrugate
paper etc.
1
Lay the unit down slowly.
Lay the unit down on some corrugate paper to
prevent damage.
2
Pull out the water drainage hose from
the right side of the unit.
1 Remove the right water drainage hose cove
(The cover can be disposed).
2 After pulling out the Black mark of the
water drainage hose from the left groove of
the unit , the Purple mark of the water
drainage should be inserted into the
corresponding groove of the right unit.
3 The water drainage hose should be pulled out
through the proper hose retainer when the hose
is pulled out on the right.