Filter
Top Products
8
Installation Guide (continued)
( )
Installation of Washing Machine
1
Adjust the instability of the washing
machine with adjustable leg.
2
Please make sure of the horizontality of the
washing machine.
As shown in the figure, the horizontality can be easily
observed by the string used to hang an object.
It is level if the
clearance between A
and machine body is
the same with that
between a and the
machine body.
A
string
A
A
object
(front or
profile)
Put some water into the washing barrel and reconfirm its
horizontality.
The ground is level if all front, rear, left and right height difference between
the spinning hole and water surface are less than 3mm.
(B C ) 3mm
To install the machine on an inclined floor, leg caps in the attached accessory kit can
be used to adjust height by connecting them to the fixed leg.
Inspection of trial run
How to Use the Adjustable Leg
1
Loosen the lock nut by unscrewing in
arrow direction 1 before using the
adjustable leg to stabilize unit.
1
2
After adjusting of the unit, tighten
the lock nut by screwing it in arrow
direction.
2
Lowering
Loosening
Lock nut
Adjustable leg
Elevating
Maximum adjust able
range is 40mm.
Tightening
Lock nut
Plastic base
Tighten the lock nut until it reaches the plastic base.
At most 40mm
40mm
BC
Fixed leg
Adjustable leg