Filter
Top Products
50
When Failure Happens (continued)
( )
It buzzes or sounds "Hoola, hoola"
during the high-speed washing or
dehydration.
Sprinking
rinsing turns into water
storing rinse or water charging
rinse.
When the washings is not much,
water can't be poured over the clothes
in sprinking rinising mode.
Supply water during the course of
spinning.
Supply water and start rinsing
during the course of spinning.
Spin intermittently after start
spinning.
The lid can't be opened even when
the PAUSE button is pressed
during the spinning.
The power supply switch won't work right
away even when the ON/OFF button is
pressed during the spinning.
Relatively low water level
compared with the washings
load.
Relatively high water level
compared with the washings load.
There are much floss.
Washing doesn't finish beyond the
predefined time.
• That is the electromagnetic sound of the motor switched on and
off to control the rotating speed.
• It is because the clothes oblique cause the action of the security
switch.
• It doesn't matter that the water is hard to be poured over the
clothes since there are not much washings.
• The security switch acts as the laundry declines.
Change automatically to the "Water-injection rinse" for the next
rinsing.
• The security switch acts as the laundry declines.
Start spinning and agitating after rinsing, and the spinning will go
on after clearing the laundry declination.
• It is because the sensor control the spinning times to improve the
efficiency of spinning.
• When the power supply is cut off, the basket stops completely,
and the lid lock will be unlocked.
• The power supply switch won't work until the basket stops the
inertial rotation.
• The setting of the water level is based on the extent of the washings
in the washing machine emerging out the water surface and the
ability of the clothes roll up and down in the washing machine.
• Since the clothes of chemical fiber is comparatively light, the
water level is set accordingly low.
• The water level will rise during washing if the clothes being
washed have been drenched or water has been charged in advance.
•
If there is much floss in "NORMAL" process, the efficiency of the
floss filtering can be improved by increasing the water consumption,
extending washing time and setting rinse for more times.
• The washing time may exceed predefined time in case of extremely
small amount of charged water.
About the
sound
About
the
spinning
About
the rinse
About
the water
level
About
the lint
filter
About the
washing
duration
Case Cause