Filter
Top Products
16 PNEG-552 100 Series Dryer
3. Dryer Control Panel
Setting the Dry, Cool, Unload and Out of Grain Timers
These switches are used to set the drying cycle times in the staged batch drying mode only. The drying
mode switch must be in the staged batch position. Out of grain sets the length of time the dryer will run
before shutting down when the load switch is in the AUTO position. To change the setting of these
timers, follow these instructions:
1. Press the PROGRAM (TIMERS) button until the “carrot” (See Figure 3C) is above the timer you
want to modify.
2. Use the UP and DOWN arrow keys to change from the present time to the desired setting. The new
time is automatically accepted.
3. Keep pressing the PROGRAM (TIMERS) button until the carrot disappears or press the mode
select button once to exit.
During the operation, the remaining time on each timer is displayed on the screen. If the power goes out
or if the dryer is stopped, these times are saved by the controller. When the dryer is restarted the timers
will continue timing down. The timers will return to their initial settings by pressing and holding the “stop”
button for 5 seconds.
Figure 3C Dryer LCD Display
Setting the Load and Unload Delays
The load delay is used to delay the starting of the load auger when the dryer is unloading to prevent the
load auger from starting and stopping too often. The unload delay is used to control the amount of time
the unload auger runs after the metering rolls stop to allow for auger clean-out.
1. Press the PROGRAM (DELAYS) button until the carrot is under the time delay to be changed.
2. Use the UP and DOWN arrow keys to change from the present time to the new one. The new time
is automatically entered.
3. Keep pressing the PROGRAM (DELAYS) button until the carrot disappears or press the mode
select button once to exit.
“CARROT”