Filter
Top Products
Position the base into the recess with its
front edge as far forward as the adjoining
plinth line will allow.
The reason for placing the base in this position is
to allow a small strip of beading to be fitted in
front of the appliance feet.
Fix the base firmly to the floor using four
appropriate countersunk screws (see Fig. H).
With the appliance installed adjust all four feet
ensuring the machine is stable, and a clearance of
approximately 5 mm is left between the top of the
machine and the underside of the worktop.
A final check for stability should be carried out with the machine on spin with a load,
this will identify the need for any further fine adjustment to the feet.
A strip of beading approximately 605 mm W, x 5 mm H, x 25 mm D must be screwed
down into the base directly in front of the machine’s feet, this will provide additional
security.
If required an additional door magnet, part number 1242394-00/3 and disc, part number
1242393-00/5 are available from spare parts.
45
Installation
600-605
5 X 25 X 605
Hardwood strip
5 mm x 25 mm
H
490
132963770_en.qxd 21/07/2008 8.25 Page 45