Filter
Top Products
c) Mounting the door
Fix the hinges (1) to the machine by means of the M5x15 screws (3-Fig. B). The
hinges can be adjusted to compensate for possible uneven thickness of the door.
To align the door perfectly it is necessary to loosen the screw (3-Fig. B), adjust
the door and tighten the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a magnetic clo-
sure of the door. To enable a correct operation of
this device, it is necessary to screw the counter-
magnet (6) (steel disk + rubber ring) into the
inner side of the door.
Its position must correspond to the magnet (4)
on the appliance (see picture D).
If the door has to be opened from left to right,
invert the position of the plates (7), the magnet
(4) and the plate (5) (Fig. B and E). Mount the
countermagnet (6) and the hinges (1) as
previously described.
Recommendations regarding the construction and fitting of a
base when the installation requires an integrated appliance to be
raised
Where the appliance has been raised by mounting
onto a wooden base provided by the installer. The
material used to construct the base should have a
non slip surface, be water repellent and if possible
be one solid piece.
If it is not possible to use one solid piece, due
to the additional height required, ensure that
any additional strips of timber are glued and
screwed to the underside of the base
(see Fig.F).
Drill four fixing holes see Fig. G
44
Installation
6
4
8
D
4
6
5
1
2
3
7
8
E
600-605 mm
50 mm
Front edge
Top view
95 mm
490 mm
G
132963770_en.qxd 21/07/2008 8.25 Page 44