Filter
Top Products
34
What to do if...
No water is visible in the drum:
Machines based on modern technology operate very
economically using very little water without affecting
performance.
Problem Cause possible/Solution
The door will not open:
The programme is still running.
• Wait until the end of washing cycle.
The door lock has not been released.
• Wait until the pilot light DOOR has gone off.
There is water in the drum.
• Select drain or spin programme to empty out the
water.
The machine vibrates or is noisy:
The transit bolts and packing have not been removed.
• Check the correct installation of the appliance.
The support feet have not been adjusted
• Check the correct levelling of the appliance.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Maybe there is very little laundry in the drum.
• Load more laundry.
Spinning starts late or the machine
does not spin:
The electronic unbalance detection device has cut in
because the laundry is not evenly distributed in the
drum. The laundry is redistributed by reverse rotation
of the drum. This may happen several times before
the unbalance disappears and normal spinning can
resume. If, after some minutes, the laundry is still not
evenly distributed in the drum, the machine will not
spin.
• Redistribute the laundry.
The load is too small.
• Add more items, redistribute the load manually and
then select the spinning programme.
If you are unable to identify or solve the problem,
contact our service centre. Before telephoning,
make a note of the model, serial number and
purchase date of your machine: the Service Centre
will require this information.
Mod. ..........
Prod. No. ...........
Ser. No. .........
M
o
d
. ......
....
P
r
o
d
.
N
o
. ..
...
......
S
e
r
. N
o
.
.
........
P0042 BD
132963770_en.qxd 21/07/2008 8.25 Page 34