Filter
Top Products
If you fit your own plug, the colours of the wires in the mains lead of your appli-
ance may not correspond with the markings identifying the terminals in your plug,
proceed as follows:
Connect the green and yellow (earth) wire to the terminal in the plug which is
marked with the letter «E» or the earth symbol or coloured green and yellow.
Connect the blue (neutral) wire to the terminal in the plug which is marked with
the letter «N» or coloured black.
Connect the brown (live) wire to the terminal in the plug which is marked with the
letter «L» or coloured red.
The plug moulded on to the lead incorporates a fuse. For replacement, use a 13
Amp BS1363/
AA
fuse. Only ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indi-
cated by the coloured insert at the base of the plug.
A replacement cover/carrier must be obtained from your local AEG/ELECTROLUX
Service Centre.
The power supply cable must be easily accessible after installing the
machine.
Should the appliance power supply cable need to be replaced, this MUST
be carried out by a Service Centre.
Permanent connection
In the case of a permanent connection it is necessary that you install a double pole
switch between the appliance and the electricity supply (mains), with a minimum
gap of 3 mm between the switch contacts and of a type suitable for the required
load in compliance with the current electrical regulations.
The switch must not break the yellow and green earth cable at any point.
This operation must be performed by a qualified electrician.
42
Installation
132963770_en.qxd 21/07/2008 8.25 Page 42