Filter
Top Products
care and cleaning electrolux 25
Cleaning the water inlet filter
If your water is very hard or contains
traces of lime deposit, the water inlet
filter may become clogged.
It is therefore a good idea to clean it
from time to time.
Turn off the water tap. Unscrew the
water inlet hose. Clean the filter using a
hard bristle brush. Tighten up the inlet
hose.
The dangers of freezing
If the machine is exposed to
temperatures below 0°C, certain
precautions should be taken.
• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the emergency
emptying hose and that of the inlet
hose in a bowl placed on the floor
and let water drain out.
• Screw the water inlet hose back on
and reposition the emergency
emptying hose after having put the
cap on again.
• When you intend to start the
machine up again, make sure that
the room temperature is above 0°C.
P1231
Emergency emptying out
If the water is not discharged, proceed
as follows to empty out the machine:
• pull out the plug from the power
socket;
• close the water tap;
• if necessary, wait until the water has
cooled down;
• place a bowl on the floor and place
the end of the emergency emptying
hose into the bowl. Remove its cap.
The water should drain by gravity into
the bowl. When the bowl is full, put
the cap back on the hose. Empty the
bowl. Repeat the procedure until
water stops flowing out;
• clean the pump if necessary as
previously described;
• replace the emergency emptying hose
in its seat after having plugged it;
• screw the pump cover.
132964640.qxd 19/07/2008 12.01 Page 25