Filter
Top Products
all buttons and the programme knob. The child lock can be activated or deactivated
by holding down the OPTION OPTIE and OK buttons simultaneously for 5 seconds.
– Before programme is started: Appliance cannot be used
– After programme is started: Programme in operation cannot be changed
The
icon appears in the display to indicate that the child safety device is
activated.
The child safety device is not deactivated once the programme comes to an end.
If you want to set a new programme, you must first deactivate the child safety
device.
Starting the programme
Press the START PAUSE START PAUZE button.
The programme is started.
The programme progress is shown in LCD by
appropriate set of icons. From left to the right,
from IRON DRY
to ANTI-CREASE icon
depends on the drying cycle chosen. E. g. in
case of CUPBOARD programme the following
status icons are visible:
.
Current cycle progress is marked by flashing dash under status icon. When appro-
priate part of drying cycle is accomplished dash becomes steady and appears
flashing under next status icon.
Changing programme
To change a programme which has been selected by mistake once the programme
has started, first turn the programme selector to OFF UIT and then reset the pro-
gramme.
The programme can no longer be changed directly once the programme has started.
If nevertheless there is an attempt to change the programme on the programme
knob, the programme progress display and the maintenance indicators flash. If an
option button (excluding the BUZZER option) is pressed, Err appears in the multi-
display. The drying programme is not however affected by this (laundry protection).
Daily use
21