Electrolux 134709300 Clothes Dryer User Manual


  Open as PDF
of 26
 
19
Reversing Door
1 Besureyouhaveadequateswingareabeforereversingdoor.
2 You will need a screw driver with a #2 square bit.
3 Protectatworksurface,suchastopofdryeroroorneardryer,
with a soft cloth or towel.
4 Besuredryerisunpluggedfrompowersource!
WARNING
ELECTRICALSHOCKHAZARD
Failure to disconnect power source before servicing
couldresultinpersonalinjuryorevendeath.
A)RemovingTrimRing
1 Open door to 90 degree angle.
2 Remove and save trim plug and long,
course-thread, panhead screw.
3 Close door.
4 Rotatedoortrimapproximately¾”counter-
clockwise and pull ring away from door.
4 Gentlyplacedoorfacedownonat,covered
work surface.
3 While supporting door with the other hand,
remove 3 short, fine-thread, counter-sunk
screws.
B)RemovingDoorfromFrontPanel
1 Reopen door to 90 degree angle.
2 Remove 2 short, course-thread, panhead
screws.
Preparing to reverse door swing
Removing door and hardware
Screwdrivers with
#2 square &
straight bit
Tools needed:
 previous next