Electrolux 134709300 Clothes Dryer User Manual


  Open as PDF
of 26
 
17
General installation
NOTE
A wiring diagram and technical data sheet are
located inside the dryer console.
Grounding type
wall receptacle
Power cord with
3-prong grounded plug
Do not, under
any circumstances,
cut, remove,
or bypass the
grounding prong.
IMPORTANT
Besurethepowerisoffatacircuitbreaker/fuse
boxbeforepluggingthepowercordintoanoutlet.
Connecttheexhaustducttotheoutside1.
exhaustsystem(seepages5through7).Use
ofa4”(10.2cm)clampisrecommendedto
connectthedryertotheexhaustventsystem.
Usemetalfoiltapetosealallotherjoints.
Carefully slide the dryer to its final position. 2.
Adjustoneormoreofthelegsuntilthedryeris
restingsolidlyonallfourlegs.Placealevelon
topofthedryer.ThedryerMUSTbeleveland
resting solidly on all four legs. Rock alternating
corners to check for stability. Remove and
discard door tape.
Plugthepowercordintoagroundedoutlet.3.
Turn on the power at the circuit breaker/fuse 4.
box.
Read the 5. Use & Care Guide provided with
the dryer. It contains valuable and helpful
information that will save you time and money.
Seethenextpageaboutperformingabrief,6.
helpful“InstallationCycle”foryournewdryer.
If you have any questions during initial 7.
operation,pleasereviewthe“AvoidService
Checklist” in your Use & Care Guide before
calling for service.
Placetheseinstructionsinalocationnearthe8.
dryer for future reference.
Installation Instructions
 previous next