Electrolux 134709300 Clothes Dryer User Manual


  Open as PDF
of 26
 
13
4-wire receptacle
(NEMAtype14-30R)
Installation Instructions
Electrical connection (non-Canada) - 4 wire cord
Turn off power supply to outlet. 1.
Remove the screw securing the terminal block 2.
access cover in the lower corner on the back of
the dryer.
Install a UL-approved strain relief according 3.
to the power cord/strain relief manufacturer’s
instructions in the power cord entry hole below
the access panel. At this time, the strain relief
should be loosely in place.
ThreadanUNPLUGGED,UL-approved,304.
amp.powercord,NEMA14-30typeSTor
SRDT, through the strain relief.
Disconnecttheinternal(BLACK)dryerharness5.
groundwirefromthe(GREEN)groundscrew
nexttotheterminalblock.
Attachtheground(GREEN)powercordwire6.
tothecabinetwiththeground(GREEN)screw.
Tighten the screw securely.
Movetheinternaldryerharnessground7.
(BLACK)wiretotheterminalblockandattach
italongwiththeneutral(WHITE)powercord
wire conductor to the center, SILVER colored
terminal on the terminal block. Tighten the
screw securely.
AttachtheREDandBLACKpowercord8.
conductorstotheouter,BRASScolored
terminals on the terminal block. Tighten both
screws securely.
WARNING
ELECTRICALSHOCKHAZARD
Do not make a sharp bend or crimp wiring/
conductor at connections.
Internal ground
(GREEN screw)
Install
UL-approved
strain relief here
Terminal screw
recovery slot
Line 1
(BRASS terminal)
Neutral
(SILVER terminal)
Line 2
(BRASS terminal)
Access cover
screw
Terminal
block
Neutral
(WHITE wire)
30 AMP
NEMA 14-30
Ground
(GREEN wire)
NOTE
If a terminal screw falls during cord installation,
it can be retrieved in the terminal screw recovery
slot below the access panel.
WARNING
ELECTRICALSHOCKHAZARD
Failure to disconnect power source before servicing
couldresultinpersonalinjuryorevendeath.
Follow manufacturer’s guidelines for firmly 9.
securing the strain relief and power cord.
Reinstall the terminal block cover.10.
Move internal ground (BLACK)
wire to neutral (SILVER)
terminal for 4-wire system.
Neutral
terminal
GREEN
ground screw
BLACK or
RED power wire
BLACK
or RED
power wire
GREEN
ground wire
WHITE
neutral wire
 previous next