Filter
Top Products
When all the instructions on the previous pages have been
completed, the machine can be installed into its operating
position using the Rollerjack
TM
handle (see section 01).
• Using the Dyson spanner, adjust the two front feet so that the
machine is perfectly stable and is touching the ground on all
four corners and cannot rock.
• Do not use wood, carpet or other material to stabilise the
washing machine.
After installation
• Run an empty 60
o
C cotton cycle with a half measure of
detergent. For the correct dosage, please follow the
manufacturer’s instructions on the detergent packaging.
(See sections 01 and 01 on how to start the machine).
• This will clean any test water out of the machine, and allow
you to check that the machine is installed and levelled correctly.
• Observe it regularly during the first wash and check
connections afterwards and during the first week, to ensure
that they have been fitted correctly.
87
4
Cold water only supply
• If there is no hot water supply, attach the cold and hot hoses
to the machine as normal. Then, attach both hoses to a
Y-piece (which can be bought from most DIY stores) and
finally connect the Y-piece to the cold inlet tap.
• Once all connections have been made, turn on the tap(s) to
check that there are no leaks, tighten by hand if necessary.
Electrical installation
Warning: This machine must be earthed
• Any electrical work required to install the washing machine
should be carried out by a qualified electrician.
• Before using your machine, check that the plug and sockets
match, and check that the voltage in your home corresponds
to the machine’s voltage.
This information is on the rating plate (see section 01).
• The machine should be plugged into an earthed socket
which can be switched on & off, and that is easily accessible
after installation.
•Do not use an extension cable or plug adapter.
• If the supply cord or plug are damaged disconnect the
machine from the socket outlet immediately. The supply cord
must only be replaced by Dyson or its appointed agents, as
special purpose tools and service techniques are required.
• If the plug supplied needs to be removed it should be cut off
and disposed of safely. Under no circumstances should the
severed plug be inserted into a socket outlet as this will
present an electric shock hazard.
European conformity information
This Dyson washing machine has been tested and conforms
to the following European Directives:
73/23/EEC Low Voltage Directive.
93/68/EEC CE Marking Directive.
89/336/EEC EMC Directive.
1
Installation
5 03
Y piece
8887_CRO2_OPS_INNERS.qxd 5/11/03 3:26 pm Page 8