Conair 15 Clothes Dryer User Manual


 
G-10 l Appendix
Connecting Conveying Lines
The vertical conveying tubes and flexible conveying hoses may have been removed
for shipping. To assemble:
1 Insert each vertical conveying tube into
its quick disconnect fitting
on the MDC. Push the tube
down until you feel it seat
snugly inside the
disconnect fitting. Tighten
the thumb screws on the
fittings to secure the tubes.
2 Secure flexible conveying hoses to the vertical tubes
with hose clamps. Insert the tube at least 1 inch
(2.54 cm) into the flexible hose. Secure the hose clamp
at least 1/4 in. (0.64 cm) from the end of the tube.
3 Attach the flexible conveying hoses to the appropriate inlet and outlet
of the vacuum receiver. Push the quick disconnect fitting on the material
conveying hose over the material inlet tube. Push the quick disconnect
fitting on the return air conveying hose over the conveying air
outlet of the vacuum receiver. Tighten the thumb screws on
the fitting.
1.5 in. diameter
material conveying hose
2 in. diameter return air
conveying hose
Quick disconnect fittings
Vacuum receiver
Vertical conveying
tubes
Hose clamps
NOTE: Do not allow the
flexible hoses to kink or
crimp.
Central
When configured as
a central dryer, the
MDC option is not
available.