Filter
Top Products
G-2 l Appendix
NOTE: Throughput rates will
vary by MDC model and type of
material. See the Specification
pages for recommended
throughputs.
Typical Applications
The MDC was designed for drying and conveying beside the press. But it can also
be used to pre-dry material in one location, and then transport the dried material to
another location for conveying into the processing machine.
The MDC can be used successfully in applications that require:
•
A contamination-free drying environment.
• Drying temperatures of 100° to 375°F (66° to 191°C).
• Throughput rates of 15 to 100 lbs (6.8 to 37.3 kg) per hour (some materials can
be run at a higher rate).
•
Dew points of -40°F (-40°C).
• Conveying material at distances up to, but not more than, 8 feet (2.4 m)
vertically and 6 feet (1.8 m) horizontally.
An aftercooler is required if:
• You are drying at temperatures over 250°F (121°C).
• Throughput rates are less than 50% of the dryer’s rated capacity.
• You are pre-drying material at temperatures over 150°F (66°C).
✐
Central
When configured as
a central dryer, the
MDC option is not
available.