Filter
Top Products
Electrical Safety
Electrical Connection
The ironer is equipped with a power cord and plug. It may only be connected, via a plug and
socket with earth connection, to 220-240 volt, 50 Hz.
§ The connection is approx. 2.6 kW. The required fuse is 16 ampere. The appliance
complies with the VDE regulations. Particular attention must be paid to the local electricity
company’s special regulations.
§ The electrical safety of the appliance is only guaranteed if it is connected to a protective
conductor system. (with earth connection) It is vital that this basic safety precaution is
taken.
§ In case of doubt, have the domestic installation checked by an expert! The manufacturer
cannot be held responsible for damages caused by a missing or damaged protective
conductor.
§ Incorrect repairs can result in unpredictable dangers for the user. The manufacturer
accepts no liability for these. Repairs may only be carried out by persons authorised by
the manufacturer.
§ The electrical connection lead and defective components may only be replaced with
genuine spare parts from the manufacturer. Only these parts are guaranteed by the
manufacturer to fully comply with the safety requirements.
§ Do not damage, remove or defeat the appliance’s safety devices or operator’s controls.
§ The ironing roller is protected with a film against dust during transportation. Please
remove the dust protection film from the ironing roller.
§ The feed board is not fitted to the ironer. It is provided as an accessory with the
appliance. Fitting the feed board is described on page 9.
Note: This ironer is a domestic appliance and is not intended for commercial or
industrial use.
5