Filter
Top Products
Section Descriptions 1-9
Before You Begin
1
[6] Stacking Section
Sheets delivered from the offset section are transported to the stacking section, and then ejected
on the stack tray. The maximum stack height is 570 mm (22.44").
Stack Stopper
This stopper moves automati-
cally to match the sheet size
which has been set on the
control panel.
Front Stack Guide
This guide arranges the sheets which are
ejected onto the stack tray. To enable offset
stacking, the inner plate of the rear stack guide
and front stack guide lift alternately, offsetting
the sheets.
Rear Stack Guide
This guide arranges sheets
which are ejected onto the stack
tray.
It moves automatically to match
the sheet size which has been
set on the control panel.
Stack Tray
This tray can stack the sheets up
to a maximum of 570 mm
(22.44").
When the stack tray is full, it
moves down automatically to the
lowest point. Insert the handle,
which is attached inside the front
cover, and pull out the tray.
Inner Plate
of Front
Stack Guide
Inner Plate
of Rear
Stack Guide
Opening the Front Stack Guide
If the sheets stack height exceeded
the stack height 550 mm (21.65”),
open the front stack guide before
pulling the stack tray.
Hold the blue handle shown in the
illustration to the left and turn it
upward. Make sure to close the
front stack guide before closing the
front cover.
When you remove the sheets from the stack-
ing section, take care not to be caught
between the stack guide and the stack tray.
Otherwise, it may lead to severe injury.
WARNING
Handle