Filter
Top Products
30 EN
There is water coming
from the bottom of the
washer.
Inlet hose connections may be
leaking.
Be sure the strainers and rubber
seals of the water inlet hoses are
solid and securely fitted.
End of the drain hose may be
loosely inserted into the waste
pipe or sink.
Tightly attach the drain hose to the
waste pipe or sink (See “Installation
Instructions, Drainage”).
House drain may be clogged.
If the house drain pipes are clogged,
call a plumber for assistance.
Filter cap of the drain pump may
not be properly fitted.
Make sure that the pump filter cap is
tightly closed.
Hose connections inside the
washer may be leaking.
Internal hose connections (e.g.
dispenser hoses, drain system)
should be checked by a service
technician.
Washer fills with water
when a process is
cancelled.
There may be hot water inside
washer.
For safety reasons, water should be
cycled in and out a couple times.
Time delay function
does not work.
Door may not be closed properly. Close the loading door.
The door will not open.
Water level might be above the
lower level of the door.
Run“Drain”,“Spin”or“Drain&Spin”
program.
Washer might be heating up the
water or it may be at the spinning
cycle.
Wait until the process is over.
Due to electrical safety
mechanism, the door can only be
opened a few minutes after the
program has stopped.
Wait until the process is over.
The door will not lock.
Door is not properly closed/Door
hinge is not aligned with lock
switch.
Check for any bulky or large items
obstructing the door to be closed.