Filter
Top Products
22 EN
items when you want to pre-treat them.
Cycle soaks the laundry in a relatively
high amount of warm water for two
hoursapproximately.Youcanusefull
load and HE “High efficiency” main
wash detergent for this cycle. Use half
of the recommended detergent dose
for the load amount to be soaked. This
program ends with a 600rpm spin cycle.
• Spin/Drain
“Drain” is used to discharge the water
without spinning the clothes. “Spin” is
used to spin dry the load with selected
spin speed. Spin and Drain may be
selected as two individual program
cycles in this model.
CYoushouldselectalowerspinspeed
for delicate wash items.
Spin speed selection
Whenever a new program is selected,
the maximum spin speed of the selected
program is shown on the display if
“spin” button is pressed once.
To decrease the spin speed, press the
“Spin” button. Spin speed decreases
gradually. Then, no spin option is shown
respectively.
No spin is shown with “” symbol.
CYoucanuse“Nospin”functionin
order to drain the water without
spinning at the end of the program.
“No spin” selection is available for all
wash cycles.
In order to protect your clothes, your
washer will not spin above 800 rpm on
permanent press cycles and 600 rpm
on delicates, wools and hand wash
cycles.
For Cottons/Regularwash cycles, spin
speed can be adjusted between 800-
1200 rpm (including no spin).
For wools, delicates and hand wash
cycles, spin speed can be adjusted
between No spin - 600 rpm.
For permanent press cycles, spin speed
can be adjusted between No spin - 800
rpm.
Auxiliary functions (Options)
Auxiliary function selection keys
Select the required auxiliary functions
before starting the program.
Auxiliary function selection
YoushouldnotselectQuickwash
and Superwash at the same time.
Superwash will be cancelled and
Quickwash will remain active in such a
case.
Auxiliary function that is not compatible
with the program cycle cannot be
selected.(see “Cycle Selection Table”).
Quick wash
This function can be used for Cotton/
RegularwashandPermanentPress
programs. It decreases the washing
times for lightly soiled items.
Super wash
This function can be used for all wash
cycles except for “Soak”. It increases
washing times for heavily soiled items
for good wash results. This function
also increases the rinse water amount
of Cottons/Regularwash cycle for a
more intense rinse. Washer will only
take in cold water when this option is
chosen.
Extra rinse
With this function, you can increase the
number of current rinsing steps. Thus,
sensitive skins’ risk of being affected by
the remaining detergent on the clothes
will be decreased.
Time display
The display shows the time remaining
for the program to complete while a
cycle is running. Time is displayed in
hours and minutes as “01:30”.
CProgramdurationmaydifferfrom
the values in the consumption
table subject to the changes in the
water pressure, water hardness and
temperature, ambient temperature,
type and amount of laundry, auxiliary
functions selected, and changes in
the supply voltage.
Time delay
With the “Time delay” function you can
delay the program start up to 24 hours.
Time delay can be set with steps of one
hour for the first three hours and with