Filter
Top Products
28 EN
below:
•Pullouttheemergencydrainhose
from its housing.
•Placealargecontainerattheendof
the hose. Drain the water off into the
container by pulling out the plug at
the end of the hose. If the amount of
water to be drained off is greater than
the volume of the container, replace
the plug, pour the water out, then
resume the draining process.
•Afterdrainingprocessiscompleted,
replace the plug into the end of the
hose and fit the hose back into its
place.
•Whenthereisnowaterleft,turnthe
pump filter until it is completely loose
and remove it.
•Cleananyresiduesinsidethefilter
as well as fibers, if any, around the
impeller region.
•Neverforcethefilterwhilereplacingit
into its housing. Fit the filter fully into
itshousing;otherwise,watermay
leak from the filter cap.
4- Close the filter cap.
Close the two-piece filter cap of your
product by pushing the tab on it.
Close the one-piece filter cap of your
product by fitting the tabs on the bottom
into their positions and pushing the
upper part of it.
Descaling the washer
Hard water can cause scale build-
up inside the drum and other parts
of your washer in time. Scaling may
lead to some serious problems such
as clogging in hoses, heater or pump
failure eventually.
To prevent scaling, wash drum
should be cleaned frequently. Do not
use abrasive materials such as metal
wool while cleaning the drum.
Take the manufacturer’s instructions
into account if you are using a
descaling agent. Descaling agents
may contain materials that are
hazardous for washer components.
Use descaling agents compatible for
use in clothes washers.
When using a powder descaling
agent, add 1 cup to the main wash
compartment of the dispenser and
run a regular hot cycle (with extra
rinse) without any clothes and
detergents.