Filter
Top Products
10 EN
Allowable Clearances for
Undercounter Installation
The dimensions are for the
recommended spacing. Counter depth
should be 23.5-24.5”(60-62 cm).
Custom undercounter installation –
Washer only
Minimum counter width should be 50”
(127 cm) for a pair of Blomberg washer
&dryer.
Custom undercounter installation –
Washer&Dryer
Allowable Clearances for
Closet Installation
When installed in closet (washer only/
washer dryer stacked) :
Sides, Rear, Front 1/2 in. (1.27 cm),
Top= 1 in. (2.54 cm)
Closet door ventilation requirement: A
louver having minimum 23 in2 (148 cm2)
air opening located at 3 in (7.62 cm)
from the bottom of closet door.
Stacked Installation
YoucanstackyourBlombergwasher
and dryer (model no: DV 16540 NBL00)
byusingaspecialstackingkit(Part
No.2967100100). If necessary, consult
your dealer or technical service for
supplying the stack kit. In stacked closet
installation, following configuration is
necessary:
A louver having minimum 23 in2 (148
cm2) air opening located at 3 in (7.62
cm) height from the bottom of closet
door(forwasher)&Alouverofminimum
46 in2 (297 cm2) air opening located at
3 in (7.62 cm) distance from the top of
closet door (for dryer).
Removing packaging
reinforcement
Tilt the washer to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
Removing shipping bolts
A WARNING - Shipping bolts must
be removed before operating the
washer! Otherwise, the appliance will
50”
(127 cm)