Filter
Top Products
8 - EN
AWARNING - Risk of fire
•The clothes dryer (“appliance‘) installation
must be performed by a qualified installer.
•Install the appliance according to the
manufacturer’s instructions and local codes.
•Do not install a clothes dryer with flexible
plastic venting materials. If flexible metal (foil
type) duct is installed, it must be of a specific
type identified by the ap pliance manufacturer
as suitable for use with clothes dryers. Flexible
venting materials are known to collapse, be
easily crushed, and trap lint. These conditions
will obstruct the clothes dryer’s airflow and
increase the risk of fire.
• To reduce the risk of severe injury or death,
follow all installation instructions.
SAVE THESE INSTRUCTIONS
Electrical connection
Connect the appliance to a grounded outlet
protected by a fuse or circuit breaker of
suitable capacity.
3-Wire Electrical Connection
If your receptacle is a 3-wire receptacle as
shown below, you must obtain a 3-wire dryer
cord. A dryer cord can usually be found at
your local hardware supply, electrical supply or
home center. Cord should have closed loop or
upturned end wire terminating connectors.
A If the dryer is installed in a mobile home,
recreational vehicles, new branch-circuit
installations or in areas where local codes do
not permit grounding, only a 4-wire power
supply cord shall be used.
To change the cord:
1. Make sure that the dryer is not plugged into
any power outlet.
B DO NOT plug end of dryer power cord
into a live receptacle before connecting dryer
power cord to dryer terminals and closing
junction/splitter box as described below.
B DO NOT repair old power supply cords.
Power cord must be changed only by a
qualified person. There is a risk of electric
shock!
2. Remove the screw from the cover of the
junction box located at the top rear of the
dryer.
3. Remove the red, white and black wire from
the terminal block.
4. Remove the green ground wire from the
ground terminal.
5. Loosen the strain relief clamp holding the
4-wire cable.
6. Thread the 4-wire cable out through the
strain relief clamp.
7. Thread the new 3-wire dryer cord through
the strain relief clamp.
8. Attach the power cord Ground conductor
(the center wire) to the terminal labeled N.
3- wire receptacle
( 10-30R)
Typical 3- Wire Dryer Cord 240V/30 amp
NEMA 10-30 Type SRDT
3 Installation Instructions
4-wire receptacle
(14-30R)
3-wire receptacle
(10-30R)
If you have 3-wire receptacle, like
this, a 3-wire dryer cord must be
purchased locally.
Dryer shipped with cord to fit this
type 4 -wire receptacle