Filter
Top Products
23 - EN
7 Troubleshooting
Problem Cause Explanation / Solution
Drying process
takes too long.
Lint filter may not have been
cleaned.
* Clean the lint filter.
* Meshes of the filter may be
clogged. Wash with water.
Dryer does not
switch on or the
program does not
start. Dryer does
not start when set.
* It may not plugged in.
* The loading door may be ajar.
* Program may not be set or the
“Start/Pause/Cancel” button may
not have been pressed.
* “Childproof lock” may be activated.
* Make sure that the dryer is
plugged in.
* Make sure the loading door is
properly closed.
* Make sure the program has been
set and it is not in “Pause” mode.
* Deactivate the childproof lock.
Program is
interrupted for no
reason.
* The loading door may be ajar.
* Electricity may be cut off.
* Make sure the loading door is
properly closed.
* Press the “Start/Pause/Cancel”
button to start the program.
Laundry has
shrunk, become
felted or has
deteriorated.
* A program not suitable for the
laundry type might have been used.
* Dry only the laundry which is
suitable for drying in the dryer. First
check the labels on the clothes.
* Select a program a suitable low
temperature setting for the laundry
type to dry the clothes.
“End / Anticrease”
LED flashes.
* The 2-hour anti creasing program
to prevent laundry from wrinkling
may have been activated.
* Turn off the dryer and take the
laundry out of the dryer.
“End / Anticrease”
LED is on.
* Program has come to an end.
* Turn off the dryerand take the
laundry out of the dryer.
“Filter cleaning”
LED flashes.
* Lint filter may not have been
cleaned.
* Clean the lint filter.
* Meshes of the filter may be
clogged. Wash with water.
The “Drying” LED
flashes.
* A heat sensor failure has occurred.
dryer ends the program without
heating.
* Turn off the dryer and remove the
laundry. Call the authorized service.
A Call an authorized service if the problem persists.