Filter
Top Products
18 - EN
Starting the Program
1. Press the “Start/Pause/Cancel” button to
start the program.
2. The Start/Pause/Cancel button will light up
to indicate that the program has started.
Progress of program
Progress of a running program is shown
through the program follow-up indicator.
At the beginning of each program step, the
related lamp will light up and the lamp of the
completed step will turn off.
“Drying”:
- Drying level will be illuminated during the
whole drying process until the dryness
reaches “Damp Dry / Ready to Iron”.
“Damp Dry / Ready to Iron”:
- Lamp lights when the dryer reaches the
“Damp Dry / Ready to Iron” step and remains
lit until the next step.
“Regular Dry / Ready to Wear”:
- Lamp lights when the dryer reaches the
“Regular Dry / Ready to Wear” step and
remains lit until the next step.
“End / Anticrease”:
- The lamp lights when the program comes
to an end and the anti-creasing function is
activated.
C If more than one lamp lights or flashes
constantly, it means that there is a malfunction
or a failure (Please see Troubleshooting).
Changing the program after
the program has started
Press and hold the Start/Pause/Cancel button
for around 3 seconds to Cancel the program
currently running.
Select another program by rotating the
program knob.
Press the “Start/Pause/Cancel” button again
to start the new program.
C The program which is selected first will
go on even if the program selector knob
is moved and another program is selected
while the dryer is operating. You must cancel
the current program to change the drying
program.
A As the inside of the dryer will be
excessively hot when you cancel the program
when the dryer is running, activate the
ventilation program to cool it down.
A If the dryer is stopped during any drying
program, and if the position of the program
selector knob is changed, a tone will be heard
(if the Cancel Audio Warning function is not
selected). The dryer will not start even if the
Start/Pause/Cancel button is pressed, unless
the program selector knob is returned to the
initial program. The paused program must
be cancelled in order to change the drying
program.
Adding/removing laundry in stand-by
mode
In order to add or take out laundry after the
start of the program;
1. Press the Start/Pause/Cancel button to
switch the dryer to Pause mode. the drying
process will stop.
2. Open the door at the Pause position
and close it again after adding or taking out
laundry.
3. Press the “Start/Pause/Cancel” button to
restart the program.
C Laundry may be added or taken out
during a drying process, but interrupting
drying continuously will extend the program's
time and increase energy consumption.
Therefore, it is recommended to add all
laundry before the drying program is started.
Auxiliary functions
Cancel Audio Warning Signal
Your dryer will send out a tone when the
program comes to an end. If you do not want
to hear this, you need to press the Cancel
Signal button. The relevant lamp will light
when this button is pressed and the tone will
not activate when the program ends.
C You can select this function either before or
after the program starts.
Child-proof lock
There is a childproof lock to prevent any
program interruption due to the pressing of
keys while a program is running. The loading
door and all buttons except the “On/Off” key
on the panel are deactivated when the child-
proof lock is active.
In order to activate the childproof lock, pres
the Start/Pause/Cancel and Cancel Audio
Warning buttons at the same time for 3
seconds.
To start a new program after the program
ends or to stop a program, the childproof