Filter
Top Products
22 - EN
Sensor
There are humidity sensors in your machine
that detect whether the laundry is dry or not.
For sensor cleaning;
1. Open loading door.
2. Allow machine to cool off if drying has been
done recently.
3. Wipe the metal sensors with a soft cloth
dampened with vinegar and dry the sensors
afterwards.
C Clean the metal sensors at regular intervals
(4 times a year).
A Never use solvents, cleaning agents or
similar substances when cleaning as these
might cause fire and/or an explosion!
Lint filter
Lint and fibers released from the laundry in to
the air during the drying cycle are collected in
the “Lint Filter”.
C Fibres and lint are formed during wearing
and washing.
A Always clean the filter after each drying
cycle.
To clean the Filter;
1. Open loading door.
2. Remove the lint filter by pulling it up and
open the filter.
3. Clean lint, fiber, and by hand or with a soft
piece of cloth.
4. Close the filter and put it back in place.
C You can clean the filter and filter area with a
vacuum cleaner.
C Clogging may arise on the filter surface
after using your machine for some time; if this
occurs, wash the filter with water and dry it
before using again.
6 User maintenance and cleaning instructions