Beko WMB91242LC Washer User Manual


  Open as PDF
of 40
 
30 - EN
The door is jammed.
- Water level might be above the lower
level of the door.
-Machinemightbeheatingupthewater
or it may be at the spinning cycle.
- Due to an electrical mechanism, the door
can only be opened a few minutes after
theProgrammehasstopped.
-Runeitherthe“Pump”or“Spin”Programme.
- Wait until the process is over.
- Wait until the process is over.
Machinefillswithwaterwhenaprocessiscancelled.
Inside of machine may be hot.
For safety reasons cold water is added to cool the
hot wash load
Itcontinuouslyspins.Remainingtimedoesnotcountdown.(Onmodelswithdisplay)
There may be an imbalance of laundry in
the machine.
- The automatic spin correction system might have
been activated due to the unbalanced distribution of
the laundry in the drum.
- The laundry in the drum may be clustered
(bundledlaundryinabag).Laundryshouldbe
rearranged and re-spun.
- No spinning is performed when the laundry is
not evenly distributed in the drum to prevent any
damage to the machine and to its environment.
Washing time takes longer than the time specified in the manual
- Water pressure may be low.
- Supply voltage may be low.
- Input temperature of water may be low.
- There may be an imbalance of laundry in
the machine.
- Number of rinses and/or amount of rinse
water might have increased.
- The machine will wait until there is sufficient
amount of water, which will lengthen the washing
time to avoid poor washing results due to
insufficient water.
- Washing time is extended to avoid poor washing
results when the supply voltage is low.
- Cycle time is extended to heat up the water when
the input water is cold. Also, washing time can be
lengthened to avoid poor washing results.
- The automatic spin correction system might have
been activated due to the unbalanced distribution of
the laundry in the drum.
- The laundry in the drum may be clustered
(bundledlaundryinabag).
- Laundry should be rearranged and re-spun.
- No spinning is performed when the laundry is
not evenly distributed in the drum to prevent any
damage to the machine and to its environment.
- Water amount is increased to obtain a better rinse
and a rinse cycle is added when necessary.
 previous next