Beko WMB91242LC Washer User Manual


  Open as PDF
of 40
 
27 - EN
and tighten the hose nuts by hand.
Draining any remaining water
and cleaning the pump filter
Filter system in your machine prevents solid
items such as buttons, coins and fabric
fibers clogging the pump propeller during
discharging of the washing water. Thus, a
good water discharge is achieved and the
pump life is extended.
• Ifyourmachinefailstodrainthewater,
thepumpfiltermaybeclogged.You
may have to clean it every 2 years or
whenever it is blocked plugged. Water
must be drained off to clean the pump
filter.
In addition, water may have to be drained
offcompletelyinthefollowingcases:
• beforetransportingthemachine(e.g.
whenmovinghouse)
• whenthereisthedangeroffrost
In order to clean the dirty filter and
dischargethewater;
1- Disconnect or unplug the machine from
the power supply.
A
There may be water at 90°C in the
machine. Therefore, the filter must be
cleaned only after the inside water
is cooled down to avoid hazard of
scalding.
2-Openthefiltercap.Thefiltercapmaybe
composed of one or two pieces according
to the model of your machine.
If it is composed of two pieces, press the
tab on the filter cap downwards and pull the
piece out towards yourself.
If it is composed of one piece, hold it from
both sides and open it by pulling out.
C
Youcanremovethefiltercover
by slightly pushing the kick plate
downwards with a screwdriver, through
the gap above the filter cover.
3- An emergency drain hose is supplied
withsomeofourmodels.Othersarenot
supplied with this item.
If your product is supplied with an
emergency drain hose, do the following as
showninthefigurebelow:
• Pulloutthepumpoutlethosefromits
housing.
• Placealargecontainerattheendof
the hose. Drain the water off into the
container by pulling out the plug at the
end of the hose. If the amount of water
to be drained off is greater than the
volume of the container, replace the
plug, pour the water out, then resume
the draining process.
• Afterdrainingprocessiscompleted,
replace the plug into the end of the
hose and fit the hose back into its
place.
If your product is not supplied with an
emergency drain hose, do the following as
showninthefigurebelow:
• Placealargecontainerinfrontofthe
 previous next