Beko WMB91242LC Washer User Manual


  Open as PDF
of 40
 
24 - EN
6
Quick instructions for daily use
Preparation
1. Turn the tap on completely. Check that
the hose is connected tightly.
2. Placethelaundryinthemachine.
3. Add detergent and softener.
Starting
1. Pressthe“On/Off”button.
2. Select the programme and the
temperature.
3. Ifdesired(accordingtoyourmachine’s
model):
– select any auxiliary function,
– adjust the spin speed,
– set the time delay,
4. Close the loading door.
5. Press“Start/Pause/Cancel”button.
The display shows the time remaining for
the programme to complete if time delay is
not set.
The display shows the time remaining for
the programme to start if the time delay is
set.
6. Check if the Door Locked Symbol lights
up on the screen.
TheDoorLockedSymbol(Figure3-13i)will
light up if time delay is not set.
TheDoorLockedSymbol(Figure3-13i)will
fade if time delay is set.
Cancelling a programme
1. Pressandholdthe“Start/Pause/
Cancel”buttonforabout3seconds;the
Start symbol will start flashing.
2. The machine can discharge all the
water or can take in water for 3 times
at most to cool down the clothes and
complete discharging process.
Adding more laundry
•
This is only possible under the following
conditions:
– during time delay,
C
Youmayaddorremovelaundryduring
thetimedelay(untiltheprogramme
starts).Atthebeginningofawashing
cycle(machineallowsaddingmore
laundry during a future step only if the
water level is low enough to open the
loading door or if the temperature in the
machineislow).
In order to add laundry after the start-up
oftheprogramme:
1. Press“Start/Pause/Cancel”button.
2. Opentheloadingdoorandputinmore
laundry.
3. Close the loading door.
4. Press“Start/Pause/Cancel”button.
Programme is in rinse hold mode
C
This process is shown with the flashing
spin symbol and the standby symbol
which is lit up.
If you wish to spin when the machine is in
thismode:
1. Adjust the spin speed.
2. Press“Start/Pause/Cancel”button.The
programme continues, pumps out the
water and spins.
3. The standby symbol fades out and the
start symbol lights up.
If you want to discharge the water without
spinning:
1. Press“Start/Pause/Cancel”button.
2. The standby symbol fades out and the
start symbol lights up.
3. The programme continues and only
pumps out the water.
Re-spinning the laundry
The control system for an unbalanced load
can pause the spinning in cases when the
distribution of the laundry in the drum is not
balanced.
Ifyouwanttore-spintheclothes:
1. Distribute the laundry in your machine
for a balanced load.
2. Select the spin programme.
3. Adjust the spin speed.
After the programme is finished
Programmeindicatorsymbolsonthe
screen will remain lit after the programme is
finished.“End”willappearonthescreen.
1. Opentheloadingdoorandtakeoutthe
laundry when the door locked symbol
on the display fades out.
2. Pressthe“On/Off”button.
 previous next