Beko WMB91242LC Washer User Manual


  Open as PDF
of 40
 
10 - EN
Connecting to the water supply.
Important:
• Thewatersupplypressurerequiredto
runthemachinemustbe1-10bar(0,1
–1MPa).(Practically,itisnecessary
to have 10 – 80 liters of water flowing
from the tap in one minute to have
yourmachinerunsmoothly.)Attacha
pressure-reducing valve if the water
pressure is higher.
• Connectthespecialhosesuppliedwith
the machine to the water intake valves
on the machine.
• Inordertopreventwaterleakagethat
may occur at the connection points,
therearerubberseals(4sealsforthe
models with double water inlet and 2
sealsforothermodels)attachedtothe
hoses. These seals should be used at
the tap and machine connection ends
of the hoses. The plain end of the hose
fitted with a filter must be attached to
the tap and the elbowed end must be
attached to the machine. Tighten the
nutsofthehosewellbyhand;never
use wrenches to tighten the nuts.
• Openthetapscompletelyaftermaking
the hose connection to check if there
is any water leakage at the connection
points. Turn off the tap and remove the
nut in case of any leakage. Retighten
the nut carefully after checking the seal.
To prevent any water leakage and any
other damage to be caused by it, keep
the taps closed when the machine is
not in use.
• Modelswithasinglewaterinletshould
not be connected to the hot water
tap. Laundry may be damaged or the
appliance may switch to protection
mode and not work.
When returning the appliance to its place
after maintenance or cleaning, care should
be taken not to fold, squeeze or block the
hoses.
Connecting to the drain
The water discharge hose can be attached
to the edge of a washbasin or waste water
system. The drain hose should be firmly
fitted into the drain as to not loosen in its
housing.
Important:
• Theendofthedrainhosecanbe
directly connected to the wastewater
drain or to the washbasin. The
fitting must be secured in all types
ofconnections.Yourhousemaybe
flooded if the hose falls out of its
housing during water discharging.
• Thehoseshouldbeattachedtoa
height of at least 40 cm, and 100 cm at
most.
• Incasethehoseiselevatedafter
laying it on the floor level or close to
theground(lessthan40cmabovethe
 previous next