Filter
Top Products
9
EN
difficult and the laundry may come out
excessively wet. Therefore, follow the
heights described in the figure.
• To prevent flowing of dirty water back
into the machine and to allow for easy
discharge, do not immerse the hose end
into the dirty water or drive it in the drain
more than 15 cm. If it is too long, cut it
short.
• The end of the hose should not be bent,
it should not be stepped on and the hose
must not be pinched between the drain
and the machine.
• If the length of the hose is too short, use
it by adding an original extension hose.
Length of the hose may not be longer
than 3.2 m. To avoid water leak failures,
the connection between the extension
hose and the drain hose of the product
must be fitted well with an appropriate
clamp as not to come off and leak.
Adjusting the feet
A
In order to ensure that the product
operates more silent and vibration-free, it
must stand level and balanced on its feet.
Balance the machine by adjusting the
feet. Otherwise, the product may move
from its place and cause crushing and
vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands
level and balanced.
3. Tighten all lock nuts again by hand.
A
Do not use any tools to loosen the lock
nuts. Otherwise, they will get damaged.
Electrical connection
Connect the product to a grounded outlet
protected by a fuse complying with the values
in the "Technical specifications" table. Our
company shall not be liable for any damages
that will arise when the product is used
without grounding in accordance with the
local regulations.
• Connection must comply with national
regulations.
• Power cable plug must be within easy
reach after installation.
• The voltage and allowed fuse or breaker
protection are specified in the “Technical
specifications” section. If the current value
of the fuse or breaker in the house is less
than 13 Amps, have a qualified electrician
install a 13 Amp fuse.
• The specified voltage must be equal to
your mains voltage.