Filter
Top Products
28
EN
1. Close the taps.
2. Remove the nuts of the water intake
hoses to access the filters on the water
intake valves. Clean them with an
appropriate brush. If the filters are too
dirty, take them out by means of pliers
and clean them.
3. Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
running water.
4. Replace the gaskets and filters carefully in
their places and tighten the hose nuts by
hand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents
solid items such as buttons, coins and fabric
fibers clogging the pump impeller during
discharge of washing water. Thus, the water
will be discharged without any problem and
the service life of the pump will extend.
If the machine fails to drain water, the pump
filter is clogged. Filter must be cleaned
whenever it is clogged or in every 3 months.
Water must be drained off first to clean the
pump filter.
In addition, prior to transporting the machine
(eg., when moving to another house) and in
case of freezing of the water, water may have
to be drained completely.
A
Foreign substances left in the pump filter
may damage your machine or may cause
noise problem.
In order to clean the dirty filter and discharge
the water:
1. Unplug the machine to cut off the supply
power.
A
Temperature of the water inside the
machine may rise up to 90 ºC. To avoid
burning risk, filter must be cleaned after
the water in the machine cools down.
2. Open the filter cap.
If the filter cap is composed of two
pieces, press the tab on the filter cap
downwards and pull the piece out
towards yourself.
If the filter cap is one piece, pull the cap from
both sides at the top to open.
C
You can remove the filter cover by slightly
pushing downwards with a thin plastic
tipped tool, through the gap above the
filter cover. Do not use metal tipped tools
to remove the cover.
3. Some of our products have emergency
draining hose and some does not have.
Follow the steps below to discharge the
water.
Discharging the water when the product has
an emergency draining hose:
a. Pull the emergency draining hose out
from its seat
b. Place a large container at the end of the
hose. Drain the water into the container
by pulling out the plug at the end of the
hose. When the container is full, block
the inlet of the hose by replacing the plug.
After the container is emptied, repeat the
above procedure to drain the water in the
machine completely.
c. When draining of water is finished, close
the end by the plug again and fix the hose
in its place.
d. Turn the pump filter to take it out.
Discharging the water when the product does
not have an emergency draining hose: