Filter
Top Products
Page 18
CARE CARE
CARE CARE
CARE
AND MAINTENAND MAINTEN
AND MAINTENAND MAINTEN
AND MAINTEN
ANCE INSTRANCE INSTR
ANCE INSTRANCE INSTR
ANCE INSTR
UCTIONSUCTIONS
UCTIONSUCTIONS
UCTIONS
CLEANING CLEANING
CLEANING CLEANING
CLEANING
THE LINT FILTHE LINT FIL
THE LINT FILTHE LINT FIL
THE LINT FIL
TERTER
TERTER
TER
The wear on fabrics in a tumble dryer is insignificant.
The lint caught in the lint filter is dust and fiber residue
that has been formed when the garments have been
worn. The lint filter must be cleaned after each load. If
this is not done, drying performance will suffer, as
insufficient air will pass through the drum. The machine
may also overheat after a while, which will cause it to
stop automatically.
To clean the lint filter, follow the steps below:
1. Grasp the handle and pull it
toward you.
2. Remove the filter from
the holder.
3. Open the filter and
gently brush away
any lint.
4. Fold the filter
together and return
it to the holder on
the door.
5. Push the holder in
until it snaps into
place.
CLEANING THE CONTROLCLEANING THE CONTROL
CLEANING THE CONTROLCLEANING THE CONTROL
CLEANING THE CONTROL
PP
PP
P
ANELANEL
ANELANEL
ANEL
To clean the control panel, use only a soft, warm, damp
(not wet) cloth. To prevent penetration of water into the
door lock and electrical components, never spray water
or cleaning solvent of any kind on the control panel.
Also, never use abrasive cleaners or scouring pads on
the outer surfaces because they will scratch the finish
and possibly remove the writing on the control panels.
Some paper towels may also scratch the finish.
EMPTYING THE CONDENSEDEMPTYING THE CONDENSED
EMPTYING THE CONDENSEDEMPTYING THE CONDENSED
EMPTYING THE CONDENSED
WW
WW
W
AA
AA
A
TER CONTTER CONT
TER CONTTER CONT
TER CONT
AINER (T721AINER (T721
AINER (T721AINER (T721
AINER (T721
AND AND
AND AND
AND
T781 ONLT781 ONL
T781 ONLT781 ONL
T781 ONL
Y)Y)
Y)Y)
Y)
If the dryer is not installed to pump out the condensed
water into a drain or sink, the condensation water collects
in the water container to the left of the control panel. You
should empty the container every three to five dryer
loads, depending on the spin speed you use when you
wash the clothes. For example, clothes spun at 800 rpm
will have more moisture when you take them out of the
washer than clothes spun at 1400 rpm. Therefore, the
dryer will have to remove more water.
To empty the container, follow the steps below:
1. Pull out the container.
2. Pour out the water.
3. Replace the container. You
should hear it snap into
place.
NOTE: Do not remove the water container while the
machine is running.
The condensed water is soft and safe to use for
watering plants.
If the container becomes too full, the machine with shut
down. To restart the program, empty the container and
press Start. It may be a few minutes before the machine
starts because it drains the excess water from the sump
before it restarts.
CLEANING CLEANING
CLEANING CLEANING
CLEANING
THE EXHATHE EXHA
THE EXHATHE EXHA
THE EXHA
USTUST
USTUST
UST
HOSEHOSE
HOSEHOSE
HOSE
About once a year you should remove the exhaust hose
and clean it. At this time, you should also clean the
exhaust outlet on the machine and the ventilation duct.
Periodically, you should check the dryer exhaust outside
to be sure the air flow is strong and nothing is blocking
the vent.